NEWS & INSIGHTS
Parts knowledge, industry notes and company updates
This is where we write up the questions that come up in daily work: how to choose a part, when a wear item should be replaced, and what is moving in raw materials and trade shows. Short notes rather than long essays, each one about a single clear point.
XCMG XCA4000: a 4,000-ton all-terrain crane for major wind projects
The XCA4000 is rated at 4,000 tonnes, travels at up to 70 km/h and is positioned for large wind-turbine installation work. Read article→
XCMG RP453L: a compact paver for urban roads and maintenance
With a basic paving width of 1.8–3.4 m and a maximum width of 4.5 m, the RP453L is aimed at smaller road projects and maintenance work. Read article→
XCMG XC968-EV: a charge-and-swap loader for heavy-duty handling
Rated at 6,000 kg, the XC968-EV combines fast charging and battery swapping for steel yards, power plants, stockyards and tunnels. Read article→
XCMG XE215EV: a 23.5-ton electric excavator for quieter worksites
With a 423 kWh LFP battery and a 120 kW electric motor, the XE215EV is aimed at urban, tunnel, steel-yard and scrap-handling work. Read article→
Electric vs gas screed heating: what to check when ordering replacement plates
The screed is the part of an asphalt paver that touches the mix. It runs hot, because a cold plate holds on to the mix instead of releasing it. The two common heating methods behave differently once the plate starts to wear, and that changes which part you need. Read article→
No articles in this category yet
The first batch is being prepared. If there is a topic you would like us to cover, tell us and we will look into it.
Road 1 page 5 strip
Not found what you need?
Request a Quote→ Send us the machine model, the part number or a photo of the worn item, and a named contact will reply.
